Printer Care Tips With the Right
PC peripheral printer is important. Most printers use a PC or Centronics parallel interface.
On the computer, the interface is a female connector 25-pin D type, the parallel interface to send the eight bits of data simultaneously, the printer strobe channel when said characters to be read.
Parallel interface for the reading to fall, then the printer reads the data byte, then the recognition signal is used to notify the computer that the interface is ready bertaambah weather.
Other signals are used to the computer when the interface is active or busy, an error has occurred out of paper, and others.
Printers, as well as other saranan, would benefit if treated with care.
In most printers, the cleaning tape setiapmengganti indeed too often.
To clean the printer, turn the printer off first, regardless of the plug from the electrical power outlet and remove the lid.
For laser printers, the procedures in the manual to be followed for cleaning and replacement of the cassette.
For laser-jet printer Canon type, then you need to do is clean the corona wire carefully to the toner tank to move.
You will need to replace it every three or four times a cartridge replacement.
But is it good for, when the printer is open, you can use the machine and be careful to throw dirt, toner or paper dust menumnup in it.
As for the printer or inkjet array type, then you need to do is to remove the ribbon or ink cartridges, and then see how the band moving beyond the 'main' button.
So you can change it later, next step is carefully hapulah paper dust that has fallen into the machine. Then see that no piece of paper or adhesive label paper in his way. For a thin card is usually used to clean the dirt.
Clean Head "Print
The other thing you need to note that if you can not "head" to clean matrix or daisy wheel printing using special facilities, such as those by
Perfect Data.
Facility consists of a cleanser that place by means of the printer as a paper and cleaning solution.
So you need to do is wet the skin with a solution, then run the printer to print to it (without a ribbon) while for the test.
Where this place for the remains of the dry ink is dissolved and then absorbed through the skin.
Or you can do differently, using a special cleaning cartridge inserted as a substitute.
In addition, you also need to clean (a rubber cylinder) the plates to the remaining ink to be removed when the paper was printed.
Data are perfect for a special cleaning brush molds, where it is useful to clean the affected ink plates.
But the solution that protects the bearings can also be used to clean the outside of the plate.
If any part of the printer can move freely, then put the engine lubricating oil (with notes refer to the manual for your printer use).
Most printers use bearings that are designed to require no lubrication.
If dirt or dust had soiled paper, then a drop of oil is needed to clean it up. If you need a lubricant, it is recommended to use minimum.
After you finish cleaning it then attach a ribbon or a new ink cartridge.
Perform tests to check the printer, that satisfactory printing quality.
Most printers have a control determination of the distance between the printhead and platen.
To reduce wear and tear so do ways to maximize the space that provides good print quality up.
From the above activities then the printer cover wear clean soft cloth and soap solution and then attach the back.
Put paper in the tray or type of paper carefully (do not do no maintenance), then make sure that the paper went smoothly with no regard to other parts.
From the above steps forward are:
1. Turn off the printer, remove the lid and ribbon.
2. Cleaned of dust and dirt on the printer.
3. Monitor and clean the streets and out of the paper plate.
4. Clean and replace the "head" to print.
5. Replacing the ribbon when it finished.
6. Do a test print to a satisfactory print quality.
7. Clean and return the printer cover.
8. Perform examination and ensure properly installed and the situation smoothly.
Order
Detail
